Enabling ECR Mode on PayFacto Terminals

Enabling ECR Mode on PayFacto Terminals

Enabling ECR Mode

This document explains how to activate the ECR mode with the following PAX payment terminals:

  1. A80 & A920
  2. S80
  3. S90
  4. S300
  5. D210
  6. S920
Please refer to the section that applies to your terminal.
NOTE: This document assumes that the terminal has previously been configured to use ECR mode.

A80 & A920

The A80 and A920 are Android-based terminals that use the PayFacto Gateway application to access ECR mode.

To use the Gateway application, you simply touch the Gateway PayFacto icon on the terminal’s main screen.


For more information on using the application, please refer to the PayFacto Gateway Quick Reference Guide .
NOTE: After you use the PayFacto Gateway application the first time, the terminal’s default behavior is to start the application automatically after you restart the terminal.

S80

To access ECR mode:

From the terminal’s main screen, press the yellow Correction key.

NOTE : If you need to restart the terminal, you must repeat this procedure to re-access ECR mode.

S90

To access ECR mode:

From the terminal’s main screen, press the yellow Clear key.

NOTE: If you need to restart the terminal, you must repeat this procedure to re-access ECR mode.

S300

To access ECR mode:

From the terminal’s main screen, press the yellow • key.

NOTE: If you need to restart the terminal, you must repeat this procedure to re-access ECR mode.

D210

To access ECR mode:

From the terminal’s main screen, press the yellow < key.

NOTE: If you need to restart the terminal, you must repeat this procedure to re-access ECR mode.

S920

To access ECR mode:

From the terminal’s main screen, press the green O (OK) key and 5 at the same time.

NOTE: If you need to restart the terminal, you must repeat this procedure to re-access ECR mode.